Exocad tooth model editor-Error

Discussion in 'exocad' started by rudi_9999, Oct 25, 2019.

  1. rudi_9999

    rudi_9999 New Member

    Unbenannt2.JPG Unbenannt.JPG Hey there,
    I want to create some new tooth library.
    BUut it shows me some mistakes; think it is because those teeth are only pontics ?
    If i am right, is there a way, to change a pontic tooth into an "Library Tooth"?

    How can i create the metadata .xml file ?
    Last edited: Oct 25, 2019
  2. Vasyl

    Vasyl Well-Known Member

    Because of the pontics. You can just trim the bottom. Even in Exocad.
  3. rudi_9999

    rudi_9999 New Member

    thank you

Share This Page