Implant model valleta 2.2 bug?

Discussion in 'exocad' started by sonlab, Jul 10, 2019.

  1. sonlab

    sonlab Well-Known Member

    In the middle of designing an implant screw retained crown after I generate abutement bottoms and load custom tooth model, exocad merges the two together.

    If I go back to change generate abutement bottoms and move the control points away from the crown and hit ok, their is no new merge of the abutement bottoms with the crown.

    see screen shots

    The older version of Implant module ,the one that I had before didn't do this
     

    Attached Files:

  2. leshi

    leshi Well-Known Member

    Have you tried to send this case to support exocade?
     
  3. Toothman19

    Toothman19 Well-Known Member

    I thought the custom tooth model was loaded first and then the abutment bottom
     

Share This Page