Making screw hole thickness smaller

Discussion in 'exocad' started by mill3d, Nov 1, 2019.

  1. mill3d

    mill3d Well-Known Member

    Hi!

    Is it possible to make the screw hole thickness smaller? It is 0.2mm by default, but can it be reduced?
     

    Attached Files:

    • asd.JPG
      asd.JPG
      File size:
      95.5 KB
      Views:
      10
  2. 2thm8kr

    2thm8kr ɹotɐɹʇsıuıɯqA Staff Member

    You will have to find the parameters in: C:\MATERA\DentalCADApp\config\defaultparameters

    sc thickness.png
     
  3. mill3d

    mill3d Well-Known Member

    Thank you! Is there a way to decrease the abutment collar also so I dont have to drag the collar up every time?
     
  4. 2thm8kr

    2thm8kr ɹotɐɹʇsıuıɯqA Staff Member

    Screen shot of what you are wanting to change?
     
  5. mill3d

    mill3d Well-Known Member

    I mean this
     

    Attached Files:

    • 1.JPG
      1.JPG
      File size:
      23.4 KB
      Views:
      20
    • 2.JPG
      2.JPG
      File size:
      38.2 KB
      Views:
      16
  6. 2thm8kr

    2thm8kr ɹotɐɹʇsıuıɯqA Staff Member

    I'm not exactly sure what that is called in the software, but should be crown or abutment border it is in the same folder as post #2.
    You'll have to experiment until you find the right one. Make a back up so you can undo any changes you don't want easily.
     
    Rigant and cadfan like this.
  7. Rigant

    Rigant Well-Known Member


    As far as I know, that's limited by the overall minimum thickness of the material and type...or you modify the connection in the library so that it finishes with more thickness, or you modify the minimum thickness of the whole piece.

    I hope someone knows some other way...
     

Share This Page