Model Creator and Rised Bite

Discussion in 'exocad' started by mill3d, Feb 11, 2020.

  1. mill3d

    mill3d Well-Known Member

    Hi!

    After raising the bite in virtual articulator, how can I keep the raised bite when adding attachments? At that point it will use the original bite. I know I can export the files with new position, but the preparation lines are already marked with the restorations.
     
  2. 2thm8kr

    2thm8kr ɹotɐɹʇsıuıɯqA Staff Member

    Try the virtual articulator before marking your margins and designing or switch to expert mode and alter the margin (move and move back to original position) after design and save the margin changes.
     
    Vasyl likes this.

Share This Page