Noob question. How do I remove gingive excess?

Discussion in 'exocad' started by SBN2k, Jun 22, 2022.

  1. SBN2k

    SBN2k New Member

    Hello, I have just started the exocad journey and I have a little problem with two cases where I would like to remove excess of gingiva and some flow composite ( I have attached a screenshot) but unfortunatly I do not know how to cut out the excess. If I use the cut tool it leaves a pretty large hole the will not be filled properly.

    What would be the best way to get rid of the composite excess, or blood/gingiva excess?

    Thank you in advance
     

    Attached Files:

Share This Page