Partial

Discussion in 'exocad' started by ghost, Sep 28, 2019.

  1. ghost

    ghost Bring Happiness to all

    why is there such a lag on partial it was ok before but not its gotten worse rest of computer fine just partial any clues please
     
  2. ghost

    ghost Bring Happiness to all

    no one help
     
  3. Rigant

    Rigant Well-Known Member

    Maybe what I'm about to tell you, you've already checked...

    check that the process is included in the antivirus exceptions and that it is not disturbing.
    Check that the process opens with all the power of the graphics card.

    If everything is fine, check which computer resource is most commonly used when you run the program with LAG.

    -Graphic card to full?
    -Ram full?
    -Full processor?

    :confused::confused::confused:
     
  4. Mazve

    Mazve Member

    Partial is a bit laggy no matter what kind of a computer system you have, but i notice nothing but improvements so you probably need to check your computer condition if its getting worse
     
    Kongo-Otto, Rigant and cadfan like this.
  5. Kongo-Otto

    Kongo-Otto Love on first bite!


    Post your pc config. Which partial release you are using.
     

Share This Page