screw channel angulation shape

Discussion in 'exocad' started by ulaprostho, Jun 20, 2018.

  1. Leyla

    Leyla Member

    Hey guys
    Is there any way to change the di definition of project un the middle of the design, i mean for example i have chosen the first premolar as a pontic and and the second one as a crown and now after placing teeth i want to change it.
  2. Michael2

    Michael2 New Member

    Not sure about the middle, but you can change in database and re-save then re-open and start from scan data. I have tried before to change midstream by saving the scene then changing and re-opening the scene and if I remember right it didn't work. Good Luck!
  3. cadfan

    cadfan Moderator Staff Member

    no way to change in the middle of the process just reduced to fullcontur and opposite is possible
  4. Leyla

    Leyla Member

    In fact, you want to design a screw access crown for angulated abutment.
    Have I understood your issue
  5. Leyla

    Leyla Member

    Hey guys
    I have an angulated Abutment -25 degree- i have to design a screw access crown, how can I identify the screw channel exactly to cut off! For straight one is not difficult and i have done it so much but for angulated Abutment it looked impossible for me. Plz help me guys

    AHMADOV New Member

    2thm8kr likes this.
  7. elitedentalstudio

    elitedentalstudio Elite Dental Studio LLC

    Is this the same Code for Plovid ?
  8. 2thm8kr

    2thm8kr ɹotɐɹʇsıuıɯqA Staff Member

    It should be the same unless it has been incorporated into Plovdiv and the edit to the xml settings is no longer needed.
  9. karl

    karl New Member

    I cannot get this line of code to work with Plovdiv. I have tried defaultsettings and settings neither works, exocad does not load. Any suggestions? In desperate need to angle to 25degrees :(
  10. 2thm8kr

    2thm8kr ɹotɐɹʇsıuıɯqA Staff Member

    First, double check the syntax of the xml edit if one character is incorrect exicad will not load.
    Have you tried changing the angles without adding the xml edit. Some of these prototype tools are incorporated into newer versions of the software eliminating the need to edit the default settings.
  11. karl

    karl New Member

    Yes I can changle the angle ok already. I just need it to allow me to go to 25 degrees.
  12. 2thm8kr

    2thm8kr ɹotɐɹʇsıuıɯqA Staff Member

    I don't do a lot of angle changes on implants, so I have to wonder, is a limit to angulation set in the specific implant library you are using?

Share This Page