Touch screen

Discussion in 'Other Equipment' started by ajax826, Mar 12, 2015.

  1. ajax826

    ajax826 New Member

    Would anybody seriously use touch screen to design on Exocad? I saw it in use at DT's room in Chicago, it looks fancy! But I think I'm too lazy to use touch screen. Who wants to hold their arm out there for that long? haha
     
    DMC likes this.
  2. Toast

    Toast Well-Known Member

    I agree. I bought a surface pro to run exocad out of the lab and tried it and immediately went and bought a mouse. Kind if neat to show off maybe but would get old pretty quick.
     
  3. DMC

    DMC Scott Hudson

    no thanks
     
  4. 2thm8kr

    2thm8kr ɹotɐɹʇsıuıɯqA Staff Member

    I tried marking margins on a Trios cart with touch screen. Talk about fat fingering. Even using a stylus it was pretty useless.
     
  5. ajax826

    ajax826 New Member

    Glad to see I'm not the only one!
     
  6. Chris Silvoy

    Chris Silvoy Well-Known Member

    How about a Wacom tablet or the like?
    I just ordered one from amazon and plan to program it with the mouse buttons, ctrl, shift, and any other shortcut.
    Will take some getting used to, but I think once its setup and the learning curve is over, it will be very efficient.
    Like the 3D mouse. I love it for model manipulation.
     
  7. Yourgoes

    Yourgoes Active Member

    I have a Trios hooked up to a touchscreen laptop, it makes it easier to move the model around, but fine work like margins are easier with a mouse for sure.
     
  8. PereJ

    PereJ New Member

    How does it run on surface book?

    Sent from my SM-N950F using Tapatalk
     

Share This Page